The Beast Display Project Page
The Beast Display is current a project on Kickstarter. This page will be updated throughout the campaign with Arduino code samples, and videos that pertain to this project. If you have any questions at all after having a gander at this project page, please do not hesitate to send us a message through the "Contact us" page on our website. Thank you for taking an interest in our Kickstarter project!
The Video Manual:
The Video Manual:
Electronic Assembly, Calibration, and Test:
Code Sample#1: This code selects countdown timer mode, programs in 60 seconds, starts the timer, then resets the timer after 5 seconds in a loop. This is just used as a very basic introduction to the Beast Display:
| beastdisplay1.ino |
Code Sample#2: This code adds to the previous code sample, and adds in a wireless transmitter that acts to manually reset the timer.
| beastdisplay2.ino |
Code Sample#3: This code adds to the previous code sample. In this sample, a wireless transmitter starts and resets the timer.
| beastdisplay3.ino |
Code Sample#4: This code adds to the previous code sample. In this sample, we select up-count mode, control the display with a wireless transmitter, and increment the display when a connected vibration sensor detects movement.
| beastdisplay4.ino |
Wood Assembly Manual:
| beast_display_wood_assembly.pdf |