Engineeringshock                      Electronics
  • Home
  • Products
    • Escape Room Games/Props >
      • Interactive Games
      • Bomb Props
      • Magnetic Lock Props
      • Investment Props
      • Laser Grids
    • Feature Products
    • DIY Electronic Kits >
      • Laser Kits
      • LED Kits
      • Relay Kits
      • Security System Kits
      • Record & Playback Kits
      • Miscellaneous Kits
    • Electronic Modules & Power Supplies >
      • Power Supplies
      • Security Related
      • Relay Modules
      • Voice Changers
      • Miscellaneous
    • Parts & Components >
      • Miscellaneous
      • Actuators
      • Ultrasonics
    • The Bugger
    • RFID
    • Super Capacitors >
      • Kits/Accessories
    • Lasers
    • Security System Parts
    • Arduino
    • Paintball & Airsoft Props
  • Tutorials
  • Shipping
  • About Us
  • Privacy
  • Contact Us
  • Arduino E-Z Comms Project Page
  • The TROLL Project Page
  • The IR-XY Product Page
  • FAST RFID Project Page
  • Epoch Project Page
  • The Butler Project Page

The Vibration Detector Relay Switch Module
Instructional video in listing COOL

This listing is for a neat little vibration detection relay switch board.  This board is shipped to you with the vibration sensor module connected.  When the vibration sensor detects vibration, the relay will switch on and off, as seen in the video.  The video above offers a FULL demonstration of how this module works.  You can adjust the sensitivity of this module by turning the on board variable resistor on the main board.  It requires 5v @ >80mA to operate.  If you have any questions at all after watching the video, please do not hesitate to ask!

Interface Pins:
VCC - Supply line.  Connect 5v here.
GND - DC ground line
Relay Interface Pins (Not labelled in English.  Please see where they are in the video, as they are talked about):
COMMON PIN -  When the relay is not activated, this pin is connected to the NC (Normally Closed) Pin.  When activated, it connects to the Normally Open (NO) Pin.
NORMALLY CLOSED PIN - When the relay is off, this pin is connected to the CO (Common Pin) 
NORMALLY OPEN PIN - When the relay is turned on, this pin is connected to the CO (Common Pin)


Specifications:
Operating Voltage: 5v
Standby Current: <15mA 
With Relay Turned On: >80mA
Main Board Length: 50mm
Main Board Width: 18mm
Slot Sensor Board Length: 16mm
Slot Sensor Board Width: 15mm
Slot Sensor Board Height: 6mm

Products & Services

Featured Products
​

Company

About Us
Privacy
Shipping

Support

Contact Us
© COPYRIGHT 2015. ALL RIGHTS RESERVED.