Vibration Sensor Module for Arduino
Includes on board sensitivity adjustment
This listing is for an arduino compatible vibration sensor module with on board sensitivity adjustment via a multi-turn variable resistor. It is very easy to use! There are three interface pins: VCC (5v supply line), GND (DC Supply Ground), and OUT (Signal Output). The output is normally low, and when the module detects vibration, the output pulses high. You can make this device detect lots of vibration, or slight vibration, depending on how you have your sensitivity calibrated. It requires 5v to operate. If you have any questions, please do not hesitate to ask!
Interface Pins:
VCC - Supply line. Connect 5v here.
GND - DC ground line
OUT - This is your output lines. You connect this line to an input on your arduino, or other digital circuit!
If you have any questions, let me know.
Interface Pins:
VCC - Supply line. Connect 5v here.
GND - DC ground line
OUT - This is your output lines. You connect this line to an input on your arduino, or other digital circuit!
If you have any questions, let me know.