|
|
Dual Vibration Detector Module
Detect vibration on two planes with arduino
This listing is for a dual channel vibration detection module with two sensor boards and a main control board. This set is shipped to you with the vibration sensor modules connected to the main board via cables. When the vibration sensor boards detect vibration, the corresponding output will pulse (as seen in the above video) depending on the tuned sensitivity of that output. You can adjust sensitivity for each of the sensor boards by tuning each of the on board variable resistors. The video above offers a FULL demonstration of how this module works. It requires 5v @ >20mA to operate. If you have any questions at all after watching the video, please do not hesitate to ask!
Interface Pins:
VCC - Supply line. Connect 5v here.
GND - DC ground line
D01 - Data Output#1 corresponds to the right most vibration board module.
D02 - Data Output#2 corresponds to the left most vibration board module.
Specifications:
Operating Voltage: 5v
Operating Current: <20mA
Main Board Length: 32mm
Main Board Width: 16mm
Slot Sensor Board Length: 16mm
Slot Sensor Board Width: 15mm
Slot Sensor Board Height: 6mm
Interface Pins:
VCC - Supply line. Connect 5v here.
GND - DC ground line
D01 - Data Output#1 corresponds to the right most vibration board module.
D02 - Data Output#2 corresponds to the left most vibration board module.
Specifications:
Operating Voltage: 5v
Operating Current: <20mA
Main Board Length: 32mm
Main Board Width: 16mm
Slot Sensor Board Length: 16mm
Slot Sensor Board Width: 15mm
Slot Sensor Board Height: 6mm