Engineeringshock                      Electronics
  • Home
  • Products
    • Escape Room Games/Props >
      • Interactive Games
      • Bomb Props
      • Magnetic Lock Props
      • Investment Props
      • Laser Grids
    • Feature Products
    • DIY Electronic Kits >
      • Laser Kits
      • LED Kits
      • Relay Kits
      • Security System Kits
      • Record & Playback Kits
      • Miscellaneous Kits
    • Electronic Modules & Power Supplies >
      • Power Supplies
      • Security Related
      • Relay Modules
      • Voice Changers
      • Miscellaneous
    • Parts & Components >
      • Miscellaneous
      • Actuators
      • Ultrasonics
    • The Bugger
    • RFID
    • Super Capacitors >
      • Kits/Accessories
    • Lasers
    • Security System Parts
    • Arduino
    • Paintball & Airsoft Props
  • Tutorials
  • Shipping
  • About Us
  • Privacy
  • Contact Us
  • Arduino E-Z Comms Project Page
  • The TROLL Project Page
  • The IR-XY Product Page
  • FAST RFID Project Page
  • Epoch Project Page
  • The Butler Project Page
  • Ninja Counter Project Page
  • The ES6937 Motion Sensing Swivel Disc Project Page
  • The IR Clip Project Page

Infrared Detector Module with Remote
Receive IR signals from the remote !!!

This listing is for a tiny little infrared IR detector module and an IR remote control with battery.  The detector module also works directly with your TV remote control.  It picks up the signals sent out from any IR remote control!  The detector board is very easy to use, and only has three interface pins.  VCC (5v), GND (DC Ground), and D0 (Output).  The below video gives you a full demonstration of how it works. Please take the time to watch it.  Do not exceed a 5v supply, or else you will fry this module.   Make sure not to reverse your power lines either, as you will fry it.   The remote comes with its own battery.  There will be a little clear tab on the read side of remote when you receive it.  Pull that tab out, and your remote will be connected to power.  This tab separates the positive lead of the battery from the power input of the remote.  When you pull it out, the battery makes contact, and is then powered and ready to go.  If you have any questions, please to not hesitate to ask!  Below is a video demonstration of the receiver board.

Receiver Board Interface Pins:
VCC - Supply line.  Connect 5v here.
GND - DC ground line
D0 - Output (0-5v) 

Products & Services

Featured Products
​

Company

About Us
Privacy
Shipping

Support

Contact Us
© COPYRIGHT 2015. ALL RIGHTS RESERVED.