|
|
The Magnetic Sensing Relay Driver DIY Kit
Activates when Magnetism is Detected
This listing is for a magnetic sensing relay driver DIY electronics kit. When assembled, this device will activate an on board relay when the on board reed switch detects magnetism within close proximity. The above video offers a full set of assembly instructions, and a full demonstration. It is very easy to assemble and even comes with an additional reed switch.
Once you've assembled your kit into a fully functional device, and you power it on, the on board relay will activate when a magnet is placed in front of the reed switch (magnet sensor). When the reed switch no longer detects the magnet, the relay will turn off. The relay is a high power switch that has three output pins via a three-pin terminal block. It can be used to activate both AC and DC devices. The three pins are labelled NC (Normally Closed), CO (Common), and NO (Normally open). When the relay is inactive, the common pin is connected internally to the normally closed pin (NC). When the relay is activated, the common pin disconnects from the normally closed pin, and connects to the normally open pin.
WHAT COMES WITH THIS SET?
1) 1x magnetism sensing DIY electronics kit with two hall sensors (one pre-bent, and one extra just in case). Note: No magnet is included
A PDF of the schematic can be requested after purchase.
SPECIFICATIONS:
Power Supply Voltage/Current: 7-9VDC @ >100mA (On board 5v regulator regulates power down to 5v)
Main Board Length: 81mm
Main Board Width: 30mm
Main Board Height: 20mm
MOUNTING:
There are six small mounding holes on this board that you can choose to use if you wish. No mounding hardware is included.
Once you've assembled your kit into a fully functional device, and you power it on, the on board relay will activate when a magnet is placed in front of the reed switch (magnet sensor). When the reed switch no longer detects the magnet, the relay will turn off. The relay is a high power switch that has three output pins via a three-pin terminal block. It can be used to activate both AC and DC devices. The three pins are labelled NC (Normally Closed), CO (Common), and NO (Normally open). When the relay is inactive, the common pin is connected internally to the normally closed pin (NC). When the relay is activated, the common pin disconnects from the normally closed pin, and connects to the normally open pin.
WHAT COMES WITH THIS SET?
1) 1x magnetism sensing DIY electronics kit with two hall sensors (one pre-bent, and one extra just in case). Note: No magnet is included
A PDF of the schematic can be requested after purchase.
SPECIFICATIONS:
Power Supply Voltage/Current: 7-9VDC @ >100mA (On board 5v regulator regulates power down to 5v)
Main Board Length: 81mm
Main Board Width: 30mm
Main Board Height: 20mm
MOUNTING:
There are six small mounding holes on this board that you can choose to use if you wish. No mounding hardware is included.