The NRF24L01+ Arduino Wireless Transceiver Shield + MORE!
Project Page
ASSEMBLY VIDEO (Shield Kits):
VIDEO MANUALS:
Shield Video Manual:
Relay Board Video Manual:
8-Button Module Video Manual:
PIR Motion Sensor Video Manual:
CODE SAMPLES:
Upload this to one shield, and use the next code with another shield. See the Shield Manual Video. Modify as you see fit.
helloworld_tx_send_until_received_final.ino | |
File Size: | 2 kb |
File Type: | ino |
shield_rx_test.ino | |
File Size: | 1 kb |
File Type: | ino |
This 8-button transmitter code can be used with the shield, relay board, other 8-button boards. I'LL REFER TO THIS AS MAIN 8-BUTTONTX
8button_nrf_transmitter_final.ino | |
File Size: | 5 kb |
File Type: | ino |
This receiver code is meant for the 8-button set, and can be used to receive address/button data from other 8-button transmitters that are loaded with the above 8BUTTONTX software. This is hub software.
8button_nrf_receiver_final.ino | |
File Size: | 4 kb |
File Type: | ino |
Upload this to your shield, and open the serial monitor. This software can be used to receive data from an 8-button module loaded with the8-BUTTONTX software (above)
nrf_shield_hub_for_8button_final.ino | |
File Size: | 2 kb |
File Type: | ino |
Upload this software to your relay board. Load the below software into your shield to test your relay board, or upload 8-BUTTONTX into an 8-button module to control relays manually.
nrf_relay_start.ino | |
File Size: | 6 kb |
File Type: | ino |
Upload this software into your UNO with the shield attached to test your relay board. This software is used in the shield video manual. This is transmitter software. Modify as you'd like.
nrf_shield_relay_transmitter_final.ino | |
File Size: | 3 kb |
File Type: | ino |
Upload this software into your UNO with the shield attached, and then open the serial monitor. It will tell you where motion is detected. This is HUB software to be used with one or more PIR motion sensor modules. Please see the PIR motion sensor video manual.
wireless_pir_receiver_shield.ino | |
File Size: | 1 kb |
File Type: | ino |
Upload this software to PIR motion sensor modules. As many as 64 units can transmit room data back to the hub. Please see the PIR motion sensor video manual.
pir_transmitter_module.ino | |
File Size: | 2 kb |
File Type: | ino |
SCHEMATICS:
nrf_shield.pdf | |
File Size: | 17 kb |
File Type: |
nrf_8button.pdf | |
File Size: | 21 kb |
File Type: |
nrf_relay.pdf | |
File Size: | 26 kb |
File Type: |
nrf_pir.pdf | |
File Size: | 19 kb |
File Type: |